The threads for the Technical Forum include the following:
Pacific Dolphin Centerboard Pin (2)
Yankee Centerboard Pin/Centerboard Removal (3)
Trailers (4)
Yankee D listing to port while docked (3)
New Main Sail and Jib Furling (7)
Sheer Clamp Replaced on Yankee Dolphin 129 (4)
Topping Lifts (2)
Standing Rigging (3)
Palmer 27 Starting Problem (3)
Navigation Lens Replacement (4)
Tabernacle Installation (7)
Proper support for lifting and on the hard (6)
Masts and related stuff (5)
Tabernacle installation (2)
Keel bolts (2)
Centerboard stuck UP (3)
Furler problem (3)
New standing rigging (5)
Toe rail bolt replacement (10)
Shroud hardware (5)
Why upgrade bronze winches? (2)
Yankee Dolphin Builder Plate Font? (3)
Rewiring (4)
Cutting a new outboard well (6)
Depth sounder transducer placement (7)
Rudder unseated (3)
Full batten or not (4)
Depth sounder (3)
Yankee Dolphin mast step (7)
Is the PW 27 a practical inboard engine? (2)
Window gaskets (2)
Pacific Dolphin Spreader Brackets (2)
Outboard Shaft Length (2)
Mast mount (4)
Boom Vang (9)
Raising mast, the details (2)
Mast pumping (3)
Spinnaker Dimensions (2)
Furling genoa (3)
Mast and Boom Sections (4)
Halyard sizes (3)
Outboard moter choice (2)
Replacing Rudder (3)
Raising mast (3)
Common ground point (4)
Replacement tiller (2)
Battery location (5)
"Keel rubrail" (3)
Ballast repair (2)
Pacific Dolphin Wiring Diagram (2)
Dolphin Trailer (2)
Wilmette high-aspect mainsails (2)
Spinnaker Pole (10)
Adjustable backstay (3)
Ventilation (3)
Hull numbers/nameplates (2)
Rudder post & feeding lines through boom (9)
Pricing a Palmer Huskie (3)
Smallest outboard? (4)
Outboard Motor Question (3)
Sail plan (2)
|