The discussions for this thread include the following:
Posted: 01 Jun 2008 at 12:12pm
Morning All,
I'm in the process of rewiring and noticed that the previous owner didn't have a common ground point. I considered clamping
a ground to a through hull,but was advised against it. I have a scrap piece of copper bar that could be attached below the
motor well, or would a Dynaplate work better? Any thoughts on grounding methods would be appreciated!
thanks, greg - hull #85
Hull #85
Posted: 02 Jun 2008 at 4:16pm
Hi Greg
When I rewired Marionette 12 years ago, I used the West Marine technical guru as my advisory resource. I do not have an inboard
or a generator. I do have a mounted A/C portable charger that is always disconnected, except when charging from an A/C source at
the dock. I have a 90 amp gel cell battery. I'll get more pictures of this set up on the website.
The 12 volt 'load' potential is 2 V-berth lights, 2 Q-berth lights, a main cabin light, 3 small aircraft type 12 volt lights
above the galley shelf, running lights, a VHF radio, an autopilot, a small inverter, and an auto bilge pump. I mostly single
hand, rarely sail at night, and prefer oil lamps for the 10 minutes before I fall asleep. I have a portable solar panel which
I almost never use. The auto bilge pump and its 3 way switch is wired, with fuse, directly to the the + and - battery
terminals I plan my trips to get to a dock between 7-10 days to recharge the battery. Both the battery and the A/C charging
unit are quick disconnects in the boat so I can, if necessary, load them in the dinghy and recharge at the dock if a slip is
not available,
All my hot wires, except the bilge pump are wired to a small panel with fused circuit breakers, and all the ground wires are
connected to a common ground which is connected to the panel and on to the negative battery terminal. There is no external
grounding plate. The OB motor has no electrical connections.
If I had to do it all over again I would minimize the wiring by using independent battery pack powered LED lights.
Ron Breault
Marionette, #12
Posted: 02 Jun 2008 at 8:59pm
Ron,
Thanks for the wiring information. The old panel I removed was so corroded it was hard to tell how it was wired.
Greg #85
Hull #85
Posted: 03 Jun 2008 at 7:08am
Greg
There is a picture of Marionette's panel in the technical section of the website at:
http://www.dolphin24.org/marionette_steps_etc.html
You can see the auto bilge pump switch just below the panel. If you look closely at the left of the panel you can see
the access panel that is hinged and drops down to the starboard side so you can get to the wiring.
Ron
|
|